KUKKO Katalog 18-19

96 ISO Das Lager muss nach dem Ausbau ersetzt werden! Das Lager kann nach dem Ausbau wieder verwendet werden! ? 2 2 A world in motion since 1919! 1st step: What is the ISO number of the ball bearing? 2nd step: Reusing of the ball bearing 3rd step: Choice of the right ball bearing puller The ball bearing is in a housing and on a shaft at the same time. The ball bearing is inside a casing, but has no shaft for support. pull pull pull pull pressure 3 The bearing is replaced 3 The bearing can be used again With this puller, grooved ball bearings that are simultaneously located on a shaft and in a casing can be quickly and easily removed. Grooved ball bearings that are located in a casing but have no shaft for support can be removed using an addi- tional impact hammer. Pulling jaws specifically developed for precise mounting in bearing tracks for optimal support and better extension force. · No chips are produced Pulling jaws specifically deve- loped for precise mounting in bearing tracks for optimal support and better extension force. · No chips are produced The cage of the damaged ball bearing needs to be drilled so that the hemispheres of the pul- ling parts can be screwed in. · There arise drilling chips Series 69 Series 70 „Pullpo“ Series 70 „Pullpo“ Selection of the right ball bearing extractor The be ring mu t be replaced after removal! The bearing can be reused after removal! TIP! For an especially reliable fit of the ball bearing onto the shaft, we recommend our inductive ball bearing heater, T-AW. The ball bearing is heated, mounted on the shaft, and as it cools, is firmly pressed to the shaft. Non-contact extraction. KUKKO tool factory Ball bearing removal and fitting