KUKKO Katalog 18-19

89 www.KUKKO.com 03 Mode of operation More Separators Accessories: Extansions Accessories: long hydraulic spindles For pulling tight parts such as ball bearings, roller bearings, inner rings and simliar. The sharp, wedge-shaped blades are pressed behind the parts to be removed and, in this process, push between the bearing and the seat. For pulling, the tension bolts on the pulling device (series 18) must be screwed into the separator. Normally, a separator blade is used in combination with a pul- ler device. It is also possible to extend the puller bar for jobs involving longer shafts. In some cases, an appropriate puller from the 20 series can be used instead of the puller bar. If the separating jaws are screwed into the pulling device the other way round, then pul- ling can be carried out flush and gently. The extensive KUKKO line also supplies separators with side clamps, such as the 204 and 210 Cobra series. The adjusting nuts on the separa- tor must be tightened in alterna- ting and equal turns. Otherwise, the separator blade may tilt on the bolt or the thread may be da- maged. When pulling the separator bla- de, ensure that before the pulling device is pulled upwards the bla- de is firmly seated up to the stop under the part to be removed. The side bolts of the pulling de- vice must always be spindleed into the separator blade until they stop. Safety instructions for separating For particularly secure parts, in the larger models (from 18-2), the mechanical pressure spindle can be swapped for a hydraulic pres- sure spindle. KUKKO tool factory Separating