KUKKO Katalog 18-19

152 ST 142 Art.- No. a mm b mm c mm d mm 142-1 -555572 15 64,5 2,5 47,5 142-2 -555602 23,5 65 3 48 142-3 -555619 15 46 2,5 29 142-4 -555626 26,5 30 5 16 ST K-142 Art.- No. mm mm a mm b mm c mm d mm Stück pieces K-142/6 60 50 15-26,5 30-64,5 2,5-5 16 - 48 128-F-SW 43-1 142-1 142-2 142-3 142-4 8 i-Boxx K-142/4 60 50 15; 26,5 30; 64,5 2,5; 5 16; 47,5 128-F-SW 43-1 142-1 142-4 4 L-Boxx MINI ST 128-F-SW Art.- No. mm mm 128-F-SW -971242 60 50 K-142/4 K-142/6 KUKKO tool factory Automotive special A world in motion since 1919! Universal whiper-arm puller For pulling tight-fitting, rusted and deep-set windscreen whiper arms. Description • Mechanical pressure screw. • Milled thread treated with special coating. Advantage • Suitable for front and rear wipers with the washing fluid hose passing through the hub. • Almost all components available as replacement parts, time-saving order process thanks to numbe- ring system. Universal wiper arm puller For pulling tight-fitting, rusted and deep-set windscreen whiper arms. Description • The one-piece bell-shaped design fits on all VW, Audi, Seat, Skoda and other models. • Shaped for optimal fit with all commonly used types of wiper arms. Advantage • Windshield wiper arms can be pulled without removing the bonnet. • The threaded spindles are guided by a movable bush, which allow the puller to be fitted to the edge of the arm at the start and in the middle at the end of the removal process. • Special threads enable especially high pulling forces. • Solid, single-piece milled body for high strength. • No damage to wiper arm, shaft, etc. Universal wiper arm puller sets General purpose set used for pulling tight-fitting, rusted and deep-set windscreen whiper arms. Description • The one-piece bell-shaped design fits on all VW, Audi, Seat, Skoda and other models. • Shaped for optimal fit with all commonly used types of wiper arms. • Mechanical pressure screw. • Milled thread treated with special coating. • Instructions on the cover. Advantage • Windshield wiper arms can be pulled without removing the bonnet. • The threaded spindles are guided by a movable bush, which allow the puller to be fitted to the edge of the arm at the start and in the middle at the end of the removal process. • Suitable for front and rear wipers with the washing fluid hose passing through the hub. • Special threads enable especially high pulling forces. • Solid, single-piece milled body for high strength.