KUKKO Katalog 18-19

www.KUKKO.com 15 01 Accessories: auxiliary grease hydraulic rams Safety instructions Jawsmust always be positioned directly below the part to be re- moved. A 2-jaw puller is always used in situations where there is insuffi- cient space for a 3-jaw puller. The puller must be centrally positioned for center shafts. If the shaft is not centered, pul- ling with parallel jaws may re- sult asymmetrical pulling. The jaws must be set firmly and completely against the cross-beam. If there are several parts to be pulled, always remove them one-by-one. Never remove se- veral parts simultaneously. If there is adequate free space around the part, we recom- mend a 3-jawpuller for optimal force distribution. For use with mechanical KUKKO pullers from size 3. The auxiliary grease hydraulic rams are a good tool for significantly increasing the pressure when removing very secure parts. The hydraulic rams are simply secured between the spindle and shaft with the mechanical spindle. No conversion of the puller is needed! Accessories: Puller jaws Pullers in series 20 and 30 can easily be adjusted using different puller jaws lengths and types. Which puller jaws are right for which puller? The puller jaws that start with -1 fit all pullers of size -1 and -10 The puller jaws that start with -2 fit all pullers of size -2 and -20 The puller jaws that start with -3 fit all pullers of size -3 and -30 The puller jaws that start with -3 can also use by the pullers of size -4 and -40 Example: 20-2 has the puller jaws 2-150-P can also use: 2-151-P; 2-152-P; 2-153-P can also use long puller jaws such as: 2-300-P; 2-301-P; 2-302-P; 2-303-P Sliding-arm pullers with constantly parallel jaws KUKKO tool factory External extracting