Hazet 2019 Tool Catalogue

232 Valid until December 31, 2019 Components and spare parts from page 474 to 482 Hand tools Pullers / Extractors Puller 1x1 Always find the correct puller HAZET external pullers The most common pulling procedure is external pulling, i.e. the component to be pulled off (ball bearing, pulley, sprocket, etc.) is gripped from the outside and pulled off. The actual pulling off procedure then occurs by operating a spindle. Standard design HAZET external pullers HAZET external pullers with long puller hooks HAZET external puller with lateral tension clamp HAZET internal pullers Pullers of the HAZET series nos. 1787 F 9–35, 1787-52,1787 S-1 and 2, 1783-22 can also be used as internal pullers by simply turning the puller hook on the crossbar. A shaft in the centre of the component is required for this, against which the spindle supports itself. Internal pullers and counter stays are normally used for this application. If there is insufficient space, the counter stay should be dispensed with and a sliding hammer should be used. HAZET external pullers can also be used as internal pullers Puller application examples with specialty tools • In industry, for motor vehicle and commercial vehicle components • Pitman arm • Ball joints, ball bearings, washers, wheels • Sprockets, cogs